A split cover set that snaps over the exposed washer stack on your foot pegs, giving the axle area a cleaner look without requiring you to disassemble the peg setup. Installs after the pegs are already tightened down.

• Split Cover Design – Two-piece halves press over the washer stack from the outside. No need to remove pegs or washers to install.
• Standard 5/8" Washer Fit – Sized for standard 5/8" washers.
• Confirmed Compatibility – Fits the Revv1 DRT, HT, and FS; Super73 RX, ZX, and S2; Ridstar Q20 and Q20 Pro; and Macfox X7, X2, and X1S.
• Glue-Set Install – Apply a small amount of super glue to the inside of the covers before pressing them on. This keeps them from vibrating loose on the trail. Glue not included.

What’s in the box:

• 1x Peg Washer Cover Set (Left & Right halves, 3D-printed)