A 3D-printed adapter that converts the stock half-twist throttle on the Revv1 DRT and Revv1 FS into a full-twist setup. The modification is internal – it changes the range of motion so you get a complete rotation instead of the limited half-turn the stock throttle allows.
-
Full Rotation Conversion – Slides under the throttle tube to extend the twist range. Gives a more gradual, controlled throttle input compared to the stock half-twist.
-
3D-Printed Construction – Printed in-house and designed specifically for the Revv1 DRT and FS. Layer lines are visible – normal for printed parts.
-
Confirmed Fitment – Compatible with both the Revv1 DRT and Revv1 FS. Position the throttle so it lines up with the edge of the bars during install.
-
1-Year Warranty – Covered for one year when installed correctly per the instructions below.
Installation: Remove your stock grip and throttle. Slide the adapter under the throttle tube and apply glue to the mating surface. Let it fully cure before sliding your ODI grip over the top. If the throttle doesn’t snap back cleanly, check the install alignment and confirm the bars aren’t bent.
What’s in the box:
- 1x Full-Twist Throttle Adapter (3D-printed)
Glue not included.
